myCharge Trek 2000 RFAM-0164 - Manual (Page 3)

4 5
Thanks for choosing myCharge.
In The Box
• myCharge Trek
• Lanyard
• Owner’s Manual
• Warranty Manual
Section I: Quick Start
1. Charge up your Trek by plugging it into a USB power
adapter or computer. As Trek charges, LEDs on the unit
will sequentially illuminate. When the unit is fully charged,
all LEDs are lit. Press the level check button to see how
much power is available.
2. Connect your device to either the flip-out Apple Dock
Connector or the Micro-USB connector.
3. Unplug your iPod, iPhone, or Micro-USB device when it’s
charged and go! Your Trek will automatically power off
after your devices are unplugged.
Section II: Charging Trek
To charge your Trek, connect it to a USB power source
(Apple iPhone adapter, notebook USB port) with the on-
board green USB input cable. Times to charge the Trek
vary based on what it’s plugged into. You can expect a full
charge from an iPhone USB adapter in about three hours, or
from a standard notebook USB port in about five hours.
Note: It is normal for your Trek to be warm to the touch
while in use.
USB Charging
Cable
Apple Dock
Connector
Micro-USB
Connector
LEDs
Multifunction
Button
Charge from a USB adapter or your computer