Compaq Labtec LCS 800 - Manual (Page 6)

AlphaServer 800 Pedestal–Rackmount
2.30 Alpha Servers
Step 3b—Storage Adapters/Controllers

All systems include an onboard UltraSCSI adapter to
support a maximum of seven internal devices; four SCA-
2 hard disk drives and three removable media devices.

If the internal drives are connected to a PCI-based RAID
controller (KZPAC-xx) instead of the onboard UltraSCSI
adapter, Fault Management must be disabled when the
RCU (Raid Configuration Utility) is executed.
-
PB8HA-DA cable is required to connect optional PCI-
based RAID controller to internal disk drives.

Maximum number of KZPAC PCI-based RAID
controllers supported is four.

Charts indicate minimum level of operating system
supported.
Note: Minimum operating system level support for
DIGITAL UNIX with MEMORY CHANNEL is V4.0B.


Refer to the Supported Options List for O/S support
http://www.digital.com/alphaserver/tech_docs/alphasrv8
00/docs/supported_options.html


The following adapters and controllers are supported.

SCSI cables are not included and must be ordered
separately.

External DSSI cables are not included and must be
ordered separately.
Maximum # Supported
Order Number Description
DIGITAL UNIX
V4.0D
OpenVMS
V7.1-1H1
KZPCM-DA PCI-based two port UltraSCSI Single-ended adapter and
10/100Mbit Ethernet Combo adapter, uses 1 PCI slot. Internal 68-pin
and 50-pin HD connectors and two external 68-pin VHDCI
connectors. 2 2
BN37A-02 2 meter VHDCI male to VHDCI male UltraSCSI cable for external
connections. Required for each UltraSCSI StorageWorks shelf
attached to KZPCM.
PB8HA-DA Internal 68-pin HD SCSI cables. Connects 16-bit wide SCSI
controller KZPCM to internal storage assembly, maximum one per
system.
KZPBA-CA PCI-based one port UltraSCSI Single-ended adapter, internal 68-
pin and 50-pin HD connectors and external 68-pin HD connector. 2 2
BN38C-02 2 meter 68-pin HD male to VHDCI male UltraSCSI cable. Required
for each external UltraSCSI shelf attached to KZPBA.
PB8HA-DA Internal 68-pin HD SCSI cables. Connects 16-bit wide SCSI
controller KZPBA to internal storage assembly, maximum one per
system.
KZPBA-CB 1 PCI-based one port UltraSCSI Differential adapter, 68-pin HD
connector 2 2
BN38C-02 2 meter 68-pin HD male to VHDCI male UltraSCSI cable. Required
for each external UltraSCSI shelf attached to KZPBA.
Maximum # Supported
Order Number Description
DIGITAL UNIX
V4.0B
OpenVMS
V7.1-1H1
KZPSA-BB PCI-based one port Fast Wide Differential (FWD) SCSI adapter
with 68-pin HD external connector. Supports Single-Ended storage
devices via the DWZZA or DWZZB signal converters. Internal hard
disk drives are not supported on KZPSA adapter. 4 4
BN21K-02 2 meter SCSI cable 68-pin HD straight male connector with thumb
latches and one 68-pin HD right angle male connector with screw
fasteners.
BN31G-xx SCSI Cable 68-pin HD straight connector at each end; -xx denotes
length of cable
BN21W-0B SCSI Cable 68-pin HD SCSI "Y" Cable
DWZZB-xx SCSI bus signal converter. 16-bit differential to 16-bit Single-Ended
KZPAA-AA PCI-based one port Fast Narrow Single-Ended (FNSE) SCSI
adapter with 50-pin external connector 4 4
BN21N-02 2 meter 8-bit to 16-bit SCSI cable, connects KZPAA to 16-bit Fast10
SCSI StorageWorks shelf.