Nextteq VeriFit Irritant Smoke Generators for Respirator Fit Testing - Manual (Page 25)

Page 22 of 24
VeriFit Irritant Smoke Generators Manual
Toll free: 877-312-2333 / Toll free: 877-312-2444 www.nextteq.com
PN 50811300-340N Rev F 5/09
Operating Instructions
NOTE: Prior to compressing the bellows, ensure the smoke
generator is aimed in the correct direction and at the correct
distance from test subject.
8. Slowly, gently, and uniformly compress the bellows to generate
smoke as shown in Figure 4 below.
Figure 4 Smoke is Generated
9. When testing is complete, carefully compress the pump bulb.
When the pump bulb is compressed, replace the black cap over
the end of the smoke generator. Store in a secure, dry, cool space
away from direct light and out of the reach of children.
NOTE: The VeriFit Irritant Smoke Generator’s all-in-one design offers
convenience and easy disposal. Due to the corrosive nature
of the stannic chloride in the smoke generator, discard the
smoke generator within one day of activation.
10. When the VeriFit Irritant Smoke Generator is exhausted, carefully
compress the pump bulb. When the pump bulb is compressed,
replace the black cap over the end of the smoke generator.
Dispose of the VeriFit Irritant Smoke Generator in accordance with
all Federal, State, and Local laws and regulations as well as the
Warnings in Section III and the MSDS in Section V of this manual.