Outdoor Great Room Lodge II Pergola - Manual (Page 4)

2 Lodge II Pergola Assembly Instructions – A-Frame Assembly
Step 1:
Use construction adhesive and supplied wood screws to assemble in the
configuration shown. Apply construction adhesive to parts “D” and “L”
avoiding areas near bolt holes. Insert bolts from back side (the side not
visible in the figure below) to hold parts in position. Assemble as shown.
Insert wood screws “Y” from back side as indicated by the diagram to the
right. Remove bolts once screws are in place.
D
L
C
J
x
x
x
x x
x
x
x
x
x x
x x
x
x
x x
x
x x
x
Screw diagram 2
Step 2:
Repeat the process from step 1 on parts “D”, “L”, and “B.”
Insert bolts “U” from back side (leave hole at each end
empty for now).
D
L
B
x x
x x
x
x
x
x x
x x
x
Screw diagram 1.
IMPORTANT: Parts “B” and “J” exist in two forms. The
center A-frames of this pergola require parts “B” and “J”
with pre-drilled screw holes at one end of each beam
used to fasten the center section to the ledger beam
assembly. Make sure the screw holes are facing
outward when assembling the center A-frame in step 6.