PDR Mounts cpm100 - Manual (Page 2)

the strength of the wood studs is not sufficient, add reinforcement.
Always confirm the center of the stud is used for the installation.
Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
not install in locations where there are excessive amounts of dust,
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation. .
The internal temperature could elevate and possibly result in fire. Install the panel (4") or more away from surroundings.
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the panel
could result with injury due to the panel display falling.
Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.
be installed must be capable of long-term support of the total load of
also be taken to ensure sufficient strength to
vibration and other external forces.
anel display to fall and cause injury.
anel display + wall mount)
MAXIMUM WEIGHT - 500 Lbs. ( 227 Kg.)
INSTALLATION LOCATION
INSTALLATION ON A WOODEN CEILING
Always install so that the load is supported by a wood stud. If
Do not install on decorative posts or plaster board.
water is possible. These can result in fire or electric shock.
Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
falling.
display falls.
Do not alter any of the parts. Do not use broken parts. This
The ceiling where the mount is to
the panel display and ceiling mount. Measures should
withstand the force of earthquakes,
Note: Incorrect installation can cause the p
Total load of the panel (p
2
CAUTION
WARNING
WARNING
Rev 033108
Caution: Installation of this unit must be carried out by a qualified technician.