PDR Mounts cpm100 - Manual (Page 3)

TYPICAL APPLICATION FOR THE CPM-100
3
TILT FOR BEST VIEWING ANGLE
TYPICAL 2 X WOOD STRUCTURE
PDR MOUNT AND 1 ½” PIPE NOT
INCLUDED
SECURE TO THE
CENTER OF THE WOOD
STRUCTURE WITH AT
LEAST 2 LAG BOLTS
SUPPLIED
Install using the lag bolts and washers supplied as in
FIG 1. Make sure that the bolts are inserted into the center
of the support studs. The use of a stud finder may help locate the center of the support stud. The
CPM100 can
be used as a ceiling mount or a display mount see
FIG 2. After installing the CPM100 and pipe (not supplied)
make sure to tighten the safety screw against the 1 ½”pipe
NOTE: the support structure must be able to support 5 x the weight of the mount and display.
FIG 1
FIG 2