PDR Mounts fcp50 - Manual (Page 2)

Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
not install in locations where there are excessive amounts of dust,
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation. .
The internal temperature could elevate and possibly result in fire. Install theprojector (4") or more away from surroundings.
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
light. Strong light could result in eye fatigue during usage.
Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the projector falls.
could result with injury due to the projector falling.
Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.
projector to fall and cause injury.
projector + FCP-50
MAXIMUM WEIGHT - 50 Lbs. ( 22 Kg.)
WARNINGS AND PRECAUTIONS
INSTALLATION ON A FALSE CEILING
water is possible. These can result in fire or electric shock.
Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
falling.
Do not install where there is direct sunlight or other strong
Do not alter any of the parts. Do not use broken parts. This
Note: Incorrect installation can cause the
Total load of the
2
CAUTION
WARNING
WARNING
Rev 031208
The ceiling structure must be capable of supporting at least 5 times the weight of the projector and the FCP kit. Check with a qualified
installer to verify the ceiling’s integrity to support the projector and FCP kit per instructions. Failure to do so could cause serious injury.
Caution: installation of the unit is to be carried out by qualified technicians only. Install in an appropriate location by
checking the ceiling structure and durability for safety and accident prevention
Always install so that the load is carried by the ceiling support structure (not the false ceiling ) thru the guide wires and quick locks supplied. The ceiling structure must be able
to support at least 4 times the weight of the projector and the FCP kit.