Chauvet LED 360 - Manual (Page 13)

5. Appendix
13 8/31/2010 4:41 PM
5. A
PPENDIX
General Troubleshooting
S YMPTOM P OSSIBLE C AUSE ( S ) P OSSIBLE A CTION ( S )
Breaker/Fuse
keeps blowing

Excessive circuit load
 Check total load placed on the
electrical circuit.

Short circuit along the power
wires

Check for a short in the electrical
wiring (internal and/or external).
Device does not
power up
 No power  Check for power on Mains.
 Loose power cord  Check power cord
Fixture is not
responding to DMX
 Wrong DMX addressing

Check Control Panel and unit
addressing
 Damaged DMX cables  Check DMX cables
 Wrong polarity settings on the
controller
 Check polarity switch settings on
the controller

Loose DMX cables

Check cable connections

Faulty DMX interface

Replace DMX input

Faulty Main PCB

Replace Main PCB
Loss of signal
 Non DMX cables  Use only DMX compatible cables
 Bouncing signals  Install terminator as suggested.

Long cable / Low level signal
 Install amplifier right after fixture
with strong signal.

Too many fixtures

Install an optically coupled DMX
splitter after unit #32.
 Interference from AC wires

Keep DMX cables separated from
power cables or black lights.
If you still have a problem after trying the above solutions, please contact CHAUVET®
Technical Support.