Ounting, Orientation, Rigging – Chauvet LED 360 User Manual
Page 8: Mounting
3. Setup
8
8/31/2010 4:41 PM
Mounting
Orientation
The
Mini Moon™ LED 360
may be mounted in any position provided there is adequate room for
ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely.
Install the bracket using the included nuts, washers, and bolts. The hole in each bracket is 13 mm
in size. When rigging consider routine maintenance and control panel access. Please see the
following notes on installation.
If you do not want to use power extensions between fixtures, set them up close
together.
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
Use the included bracket for hanging with a clamp.
Safety cables must always be used.
Mounting bracket
Bottom of fixture