Petsafe Petporte Smart Flap® Microchip Cat Flap - Manual (Page 9)

9
Petporte smart fl ap ® Installation Into a Non-Glass Door
1. Attach the supplied Cutting Template to the outside of your door in the selected position ensuring that it is the right way up and is level.
2. Drill the two holes with a 7 mm (
9 /
32
”)-diameter drill bit as marked on the Cutting Template into the house door.
3. Cut out the large hole as marked on the Cutting Template by the dashed line. When cutting this hole, keep to the outside of the
dashed line to ensure that there is clearance for the Extension Tunnel.
4. Clean the area from any dust, dirt, or debris.
Note: Follow Steps 5-9 if you completed the assembly instructions (for testing) on page 7.
5. If the low voltage power supply is plugged in to the mains, unplug it.
6. Remove the interior four self-tapping fi xing screws, the large interior cover plate, and transparent door.
7. Remove the two M6 screws, which hold the exterior and the interior sections together.
8. Remove the battery, if attached.
9. Unplug the porch cable connector from the electronics board.
10. Mount the interior section through the hole with any additional Extension Tunnel sections that are required. (see Figure 11)
11. Feed the Porch Cable from the porch and external section through the door and through the rectangular opening on the interior
section. Mount the exterior section on the outside of the door over the Extension Tunnel.
12. Put the supplied M6 screws through the exterior section and screw into the interior section. Please note depending on the
thickness of your door you may need to cut the screw length down.
13. Push the Porch Cable connector onto the electronics board. Any excess cable must be routed to the right of the battery
compartment. Ensure the cable does not lay on top of the electronics board. (see Figure 12a and 12b)
14. If you require an extension lead, then plug it into the electronics board rather than the power supply. The provided power supply
then connects in the extension lead.
15. If you do not require an extension lead, attach the power cable to the power connector on the electronics board. Route the cable
along the cable guides so that the wire passes through one of the slots at the bottom of the cat fl ap closest to the power supply.
16. Replace the transparent door fl ap ensuring that the ridge around the door is facing inward.
17. Reattach the interior large cover plate using the four self tapping fi xing screws.
18. If a battery is to be used as an alternative or in addition to the power supply then attach a 9-volt PP3 battery and insert into the
battery compartment within the internal section. Click the small cover plate into place over the battery compartment.
19. When the installation of your Petporte smart fl ap ® is completed, place the two blanking plugs over the screws on the exterior frame
and the four blanking plugs on the interior frame. (Figure 13)
20. If you select not to use the Petporte smart fl ap ® utilising battery power alone, plug in the power supply. Your Petporte smart fl ap ® is
now ready to use.
_______________________________________________________________________________________
Petporte smart fl ap ® Installation Into Glass Doors or Windows
The Petporte smart fl ap ® is also designed for installation into glass and requires a circular hole of diameter 212 mm (8 3 /
8
”). Working
with glass is a skilled job and should be carried out by a professional glazier. Your glazier will need to cut a circular hole of diameter
212 mm (8
3 /
8
”) as per the glass template. If you are in any doubt then please consult with your glazier about the fi tting of the
Petporte smart fl ap ® . Once a suitable opening is formed, then install cat fl ap as described for a non-glass door beginning with step 5.
Note: Two, small M6 screws have been included.
.