Petsafe Vibration Bark Control Collar - Manual (Page 8)

8 www.petsafe.net
FR
ES
NL
IT
DE
EN
6. Trim the collar as follows (D):
a. Mark the desired length
of the collar with a pen.
Allow for growth if your
dog is young or grows a
thick winter coat.
b. Remove the Bark Control
Collar from your dog and
cut off excess.
c. Before placing the Bark Control Collar back onto your dog, seal the
edge of the cut collar by applying a flame along the frayed edge.
ON/OFF Battery Module
The PetSafe ® VBC-10 Vibration Bark Control is packaged with the battery
module installed in the “OFF” position. To activate the collar, use a coin to
turn the Battery Module counter clockwise until the arrow lines up with the
“ON” position. If the collar is not going to be used on the dog immediately
leave it in the “OFF” position.
To Insert and Remove the Battery
Note: Do not install the battery while the
Bark Control Collar is on your dog.
1. Align the line on the battery with the
triangle on the Bark Control Collar (A).
2. Use a coin to turn the battery clockwise
until the line points to the “ON”
position if you are putting it on the dog
or the “OFF” position if it is not being
put on the dog right away (B).
3. To remove the battery, turn the battery
counter-clockwise using a coin (C, D).
Do not attempt to cut into or pry open the battery.
Be sure to discard the used battery properly.
D
D C
A B