Petsafe Wireless Pet Containment System PIF-300-21 - Manual (Page 8)

8 www.petsafe.net
EN
FR
ES
NL
IT
DE
STEP 2
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for pets
with long or thick hair. Remove and retighten the Contact Points using the Test Light Tool (2A). The
Contact Points should be tightened one-half turn beyond fi nger tight. Check the tightness weekly.
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This process should be carried out within 1.5 m (5 ft) of the Transmitter.
The Receiver Collar utilizes a replaceable PetSafe
® battery (RFA-67D-11). This
unique battery is designed to make battery replacement easier and increase
water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver
Collar (triangle) (2B). Use the edge of the Test Light Tool (2B) to turn the
battery clockwise until the arrow lines up with the lock symbol on
the housing.
To remove the battery, turn the battery anti-clockwise using the edge of the
Test Light Tool (2C). DO NOT attempt to cut into or pry open the battery. Be
sure to discard the used battery properly.
If the Receiver Indicator Light is fl ashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the Receiver Collar.
Discharge all power by holding the Stimulation Level Button down until the
light is no longer illuminated. Replace with a new battery.
A replacement PetSafe
® battery (RFA-67D-11) can be found at many retailers. Contact the Customer
Care Centre or visit our web site at www.petsafe.net to locate a retailer near you.
To Set the Static Stimulation Level
Read all the steps below before attempting
to set the Static Stimulation Level. Refer to
the Function and Response Table below for
advice on setting the Static Stimulation Level
that best suits your pet.
1. Remove the clear plastic cover with the
edge of the Test Light Tool to expose the
Stimulation Level Button (2D).
2. With the battery installed, press the
Stimulation Level Button and release
when the Receiver LED Indicator Light
lights up (2E).
3. The Receiver LED Indicator Light will emit
a series of fl ashes corresponding to the Static Stimulation Level.
2A
2B
2C
2D 2E