Carbine 6850 - Manual (Page 8)

Security / Remote Start Accessories
SPST Mini Toggle Switch with
2-Pin Plug
ALA-TGLP
• Prewired with on/off plate
• 1 amp current capacity
• 2 ft. wires
PK. 12 WT. 1
L E D ’ S & V A L E T O V E R R I D E S W I T C H
LED-H
ALA-TGLP
LED Holder
LED-H
• Underdash alarm LED holder
• Fits all Carbine LEDs
• Black housing
PK. 12 WT. 1
Red 3 Volt Super Bright LED
CA-LED1
• Plastic push-in housing without load resistor
and 2-pin plug
• 2-1/2 ft. wires
PK. 12 WT. 1
CA-LED1
Accessories
8 5
D A T A B U S I N T E R F A C E S O L U T I O N S
R E L A Y A N D H A R N E S S E S
Pre-Wired Starter Disable Relay
Socket
ALA986S
• Use ALA984H 40A SPDT 5-pin relay (not
included)
PK. 12 WT. 3
2-Pin Plug Starter Disable Output
Harness
(Relay Required)
HAR-HORN
• For use when plug-in relay packs are not used
• Provides ground output for a starter
disable relay
PK. 12 WT. 1
40 Amp SPDT 5-Pin Relay
ALA984H
• 75V DC max switching voltage
• Max switch current 40A @ 14.0 V
• Life expectancy 100,000 cycles @ 40A
PK. 12 WT. 2
Four Door Diode Isolation Package
ALA-D4
• Diode isolates up to 4 doors into one alarm trig-
ger wire
• Positive or negative door trigger operation
• 8 ft. long door pin connection wire
PK. 12 WT. 1
ALA986S
ALA984H
ALA-D4 HAR-HORN
ALARM-DIS
M I S C . A C C E S S O R I E S
Power Window Roll Up/Down
Interface
ALA50-PWC3
• One module will operate two windows
• Rolls up windows automatically when security
system is armed
• Additional trigger inputs allow windows to be
rolled up and down using the Channel 2 or
Channel 3 outputs
• Thermal control circuit prevents overrun of
window motor
• Programmable load range settings
• Works on all power window systems
• Interfaces with all security systems
PK. 12 WT. 11
Wall Mounted Carbine
Alarm Demonstration
Display
ALARM-DIS
• Full-function product display
• LED display to indicate alarm
functions
• Requires a Carbine security
system to be purchased sepa-
rately
PK. 1 WT. 3
Garage Door Opener for Code
Hopping or Standard Transmitters
PLUS 10
• Works with all aftermarket garage door opening
systems that have a wall mounted open/close
switch
• Receiver capable of learning 4 different trans-
mitter codes
• Eeprom technology remembers the transmitter
code even if the power supply is interrupted
• All transmitters that will operate the PLUS 10
must be the same, either code hopping or
standard
• Requires 12 volt plug-in wall power supply
(AC120-CA10)
• U.S. Patent #5,103,221
PK. 12 WT. 11
Garage Door Opener for
Standard Transmitters
CA10
• Same features as PLUS 10 but used with stan-
dard security system remote transmitters only
• Requires 12 volt plug-in wall power supply
(AC120-CA10)
PK. 6 WT. 2
Garage Door Opener Power
Supply
AC120-CA10
• Supplies 12 Volt DC @ 300mA maximum from
120 Volts AC (wall current)
• UL listed
PK. 6 WT. 2
PLUS 10
CA10
ALA50-PWC3
AC120-CA10
Fixed-Function (Non-Upgradeable)
Vehicle Interface Solutions
Offer the Following Benefits:
• Requires no additional programming
steps
• No computer or interface needed
• Very economical when flexibility is
not a concern
Fixed-Function Vehicle Override & Data
Bus Solutions are the perfect choice
when ordering as needed or doing vol-
ume installations on applicable vehicles.
See part numbers listed below.
Reprogrammable (Upgradeable)
Vehicle Interface Solutions
Offer the Following Benefits:
• Easy upgradeability
• Free firmware upgrades / downloads
• Superior coverage offering a just-in-
time solution
Vehicle specific firmware solutions can
be downloaded directly to the module
from the Magnadyne website. An inter-
net ready PC and a simple plug-and-
play USB adapter (ALA-XLOADER) are all
that is required to “flash” a module with
new firmware. The ALA-XLOADER even
has a unique smart upgrade feature,
which automatically identifies if a newer
version of firmware is available for
download.
Thousands of possible solutions are eas-
ily searched via a user friendly and intu-
itive online install wizard to help the
user select the correct vehicle firmware
solution. Enhanced coverage, functional-
ity and greater flexibility packed into a
just-in-time solution insures that obso-
lete inventory is a thing of the past.
See part numbers listed below.
ALA-XLOADER
Fixed-Function Vehicle
Interface
Vehicle Data Bus Interface Solutions are available in either a reprogramma-
ble or fixed-function solution. These choices offer the utmost in flexibility,
inventory control, time and cost savings while virtually eliminating
obsolescence.
Reprogrammable Vehicle
Interface
ALA-XLOADER
• USB computer interface that is required to reprogram modules ALA-D2DX01 thru ALA-
D2DX07 and the ALA-D2DX510 module. Reprogramming software is available on our web
site.
PK. 1 WT. 1
ALA-D2DX01 - Platform 1
• Preprogrammed for GM door lock, alarm data control. Includes passlock/VATS bypass for
remote start (no key required). Can be reprogrammed for Ford/Lincoln, Hyundai,
Toyota/Lexus, Audi, Kia, VW, Chrysler/Dodge/Jeep, Honda/Acura, Isuzu (door lock and alarm
data only).
PK. 6 WT. 2
ALA-D2DX02 - Platform 2
• Preprogrammed for Nissan door lock, alarm data control. Can be reprogrammed for
Honda/Acura, Infinity, Nissan and Subaru. PK. 6 WT. 2
ALA-D2DX03 - Platform 3
• Preprogrammed for Dodge, Chrysler and Jeep door lock, alarm data control. PK. 6 WT. 2
ALA-D2DX04 - Platform 4
• Preprogrammed for Ford, Lincoln, Mercury PATS transponder bypass (no key required).
PK. 6 WT. 2
ALA-D2DX05 - Platform 5
• Preprogrammed for Toyota/Lexus Transponder Bypass (no key required). Can be repro-
grammed for most Japanese imports and some U.S. imports. Acura/Honda, Kia, Hyundai,
Mazda, Nissan, Chevrolet and Pontiac imports.
PK. 6 WT. 2
ALA-D2DX06 - Platform 6
• Preprogrammed for GM passlock/VATS bypass (no key required). Includes Saab and Saturn.
PK. 6 WT. 2
ALA-D2DX07 - Platform 7
• Preprogrammed for Nissan/Infinity. Transponder bypass (no key required). PK. 6 WT. 2
ALA-D2DX510 - Platform 510
• Preprogrammed for KIA. Provides a universal transponder bypass (key required) and door
lock, alarm data control. Can be reprogrammed for General Motors, Ford/Lincoln, Hyundai,
Toyota/Lexus, Audi, VW, Chrysler/Dodge/Jeep, Honda/Acura, Isuzu and Saab.
PK. 6 WT. 2
R E P R O G R A M M A B L E I N T E R F A C E S O L U T I O N S
ALA-CHDLRS
• Dodge, Chrysler, Jeep door lock, alarm data and transponder key bypass (no key required).
Fixed feature package - not upgradeable. PK. 6 WT. 2
ALA-GMDLRS
• General Motors door lock, alarm data and passlock/VATS key bypass (no key required). Fixed
feature package - not upgradeable. PK. 6 WT. 2
ALA-GMPV
• General Motors passlock/VATS key bypass required. Includes Ion and Hybrid. Fixed feature
package - not upgradeable. PK. 6 WT. 2
ALA-GMSIM
• Data starter bypass module for vehicles that do not have a start wire at the ignition key.
Requires "ground when armed" signal from the aftermarket alarm module. PK. 6 WT. 2
ALA-HONT
• Honda/Acura transponder key bypass (no key required). Fixed feature package - not
upgradeable. PK. 6 WT. 2
ALA-KESEC
• Output pulse generator provides arm/disarm signals from the factory keyless transmitter to
any factory keyless upgrade alarm system. Connects to the data port on any D2D upgrade-
able module (D2D module is required for proper operation).
PK. 6 WT. 2
F I X E D - F U N C T I O N I N T E R F A C E S O L U T I O N S
RS-TIM
RS-TIM
Remote Start Interface Module for
Transponder Anti-Theft Type Systems
• Can be used for most vehicles that require a
transponder type key to start vehicle
• Requires extra transponder key
• Only bypasses transponder system when
remote starting – factory system stays intact
• Plugs into all remote starters
PK. 6 WT. 5