Vermont Casting ST967 - Manual (Page 4)

4 20012973
3. Reinstall logs.
a. Install the rear log by mating the notch on the bot-
tom of the log with the raised notch on the back
left side of the ember bed. (Fig. 17) Ensure the
cutout in the right side of the log is sitting around
the pilot assembly and pilot is not obstructed.
(Fig. 16)
b. Install the left front log by mating the hole on the
bottom of the log with the pin in the ember bed.
(Fig. 18) Position the log over air hole in ember
bed.
c. Install the right log by mating the notch on the
bottom of the log with the raised notch on the
ember bed. (Fig. 18) Position the log over air hole
in ember bed.
d. Install top log by mating hole on bottom of log
with locating pin on top right side of rear log. (Fig.
19) Position log so it is angled down toward the
area where the front two logs meet.
4. Place conversion label on valve.
5. Replace glass and stove front.
6. Restore gas to system and relight appliance accord-
ing to Lighting Instructions in Homeowner’s Manual
or on the rating label.
7. Leak check the system using a gas leak detector
solution.
8. Relight the main burner in both the “HI” and “LO” po-
sitions to verify proper burner ignition and operation.
Conversion is complete.
�����
���������������
����
Raised Notch
Pin
Pilot Assembly
Raised Notch
LG497
Figure 17
�����
��������
����
Rear Log
LG493
Figure 16
Pilot Notch