Ryobi R10631 - Manual (Page 4)

Page 4
■ NEVER USE IN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite flammable
liquids, gases, or fumes.
■ KEEP HANDLES DRY, CLEAN, AND FREE FROM
OIL AND GREASE. Always use a clean cloth when
cleaning. Never use brake fluids, gasoline, petroleum-
based products or any strong solvents to clean your
tool.
■ STAY ALERT. Watch what you are doing and use
common sense. Do not operate tool when you are tired.
Do not rush.
■ CHECK DAMAGED PARTS. Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other conditions
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced by
an authorized service center unless indicated elsewhere
in this operator's manual.
■ DO NOT USE TOOL IF SWITCH DOES NOT TURN IT
ON AND OFF. Have defective switches replaced by an
authorized service center.
■ DRUGS, ALCOHOL, MEDICATION. Do not operate
tool while under the influence of drugs, alcohol, or any
medication.
■ CUTTING INTO ELECTRICAL WIRING IN WALLS
AND FLOORS CAN CAUSE THE BLADE AND METAL
PARTS TO BECOME ELECTRICALLY LIVE. Do not
touch metal parts when cutting into walls and floors;
grasp only the insulated handle(s) provided on the tool.
Make sure hidden electrical wiring, water pipes, and
mechanical hazards are not in the blade path when
cutting into a wall or floor.
■ AVOID CUTTING NAILS. Inspect for and remove all
nails from lumber before cutting.
IMPORTANT SAFETY RULES FOR BATTERY
TOOLS
■ Battery tools do not have to be plugged into an electrical
outlet; therefore, they are always in an operating
condition. Be aware of possible hazards when carrying
your battery tool, when making adjustments to it, or
when changing accessories.
■ USE ONLY THE CHARGER AND BATTERY
RECOMMENDED FOR YOUR BATTERY TOOL. Do
not substitute any other charger. Use of another charger
could cause batteries to explode causing possible
serious injury.
WARNING:
Never use a battery that has been dropped or received a
sharp blow. A damaged battery is subject to explosion.
Properly dispose of a dropped battery immediately. Failure
to heed this warning can result in serious personal injury.
■ DO NOT PLACE BATTERY TOOLS OR THEIR
BATTERIES NEAR FIRE OR HEAT. They may explode.
WARNING:
Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light. To
reduce the risk of serious personal injury, never use any
cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
WARNING:
A damaged battery is subject to explosion. To avoid
serious personal injury, properly dispose of a damaged
battery.
■ DO NOT CHARGE BATTERY TOOL IN A DAMP OR
WET LOCATION.
■ Your battery tool should be charged in a location where
the temperature is more than 50
°
F but less than
100
°
F. Do not store outside or in vehicles.
■ Under extreme usage or temperature conditions, battery
leakage may occur. If liquid comes in contact with your
skin, wash immediately with soap and water, then
neutralize with lemon juice or vinegar. If liquid gets in
your eyes, flush them with clean water for at least 10
minutes, then seek immediate medical attention.
■ If carrying your battery tool at your side, make sure it is
not running and your finger is not on the switch. Avoid
accidental starting.
■ SECURE WORK before applying power. NEVER hold
workpiece in your hand or across your legs.
■ WHEN SERVICING USE ONLY IDENTICAL
REPLACEMENT PARTS.
RULES FOR SAFE OPERATION (Continued)