Ryobi TSS102L - Manual (Page 14)

14 − English
ASSEMBLY
DUST BAG
See Figure 10.
A dust bag is provided for use on this miter saw. It fits over
the exhaust port on the back of the saw.
NOTE: The exhaust port also accepts 1-1/4 in. vacuum hose.
BLADE WRENCH
See Figure 11.
A blade wrench is included with this saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws. A
storage area for the blade wrench is located on the back of
the left miter fence.
WORK CLAMP
See Figure 11.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the fence or the saw table. It also prevents the
workpiece from creeping toward the saw blade. This is very
helpful when cutting compound miters. Depending on the
cutting operation and the size of the workpiece, it may be
necessary to use a C-clamp instead of the work clamp to
secure the workpiece prior to making the cut.
To install the work clamp:

Place the work clamp shaft in one of the holes located
behind the miter fence. Tighten work shaft knob to secure
the work clamp shaft in place.
 Rotate the work clamp knob to move it up or down as
needed as needed to secure the workpiece.
Fig. 11
BASE
WORK
CLAMP
Fig. 10
DUST
BAG
EXHAUST
PORT
WORK
SHAFT KNOB
BLADE
WRENCH
WORK
CLAMP KNOB