Operation – Ryobi TSS102L User Manual
Page 29
29 − English
OPERATION
NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figure 38 - 39.
NOTE: This method of cut is for crown molding between 4-5/8
in. and 5-1/4 in. tall. Do not attempt to cut molding that is larger
than 5-1/4 in. tall.
Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
Nest and secure the crown molding against miter fence
using a spring clamp and hold crown molding securely.
Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.
Slowly lower the blade into and through the crown
molding.
Fig. 39
Fig. 38
SPRING
CLAMP
SPRING
CLAMP
BOTTOM EDGE
AGAINST FENCE
CROWN
MOLDING