Unpacking, Operating instructions, Product overview – Chicago Electric Charge Regulator 96728 User Manual
Page 5: General operating instructions, Figure a
SKU 96728
For technical questions, please call 1-800-444-3353 Page 5
UnPACkinG
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
OPERATinG inSTRUCTiOnS
Read the EnTiRE iMPORTAnT SAFETY inFORMATiOn section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Product Overview
The Charge Regulator is designed to control the charging from a solar panel (not
included) into a 12 volt DC battery (not included). The charged battery then powers a
12 volt DC tool, appliance, etc.
General Operating instructions
Connect a 12 volt DC battery, solar panel, and a 12 volt DC tool, appliance, etc.
1.
as shown in the illustration below.
iMPORTAnT: Always connect the battery
first.
(See Figure A.)
HiGH VOLTAGE
(OVER-CHARGE PROTECTiOn)
(Green)
(Yellow)
CHARGinG
LOW VOLTAGE
(DiSCHARGE PROTECTiOn)
(Red)
TO
BATTERY
TO
SOLAR
PAnEL
TO
LOAD
FiGURE A
BATTERY
SOLAR PAnEL
LOAD
nOT inCLUDED
+
--