HMDX Cube Wireless Bluetooth® Alarm Clock EN - Manual (Page 3)

4 5
SETTING CLOCK TIME
(FIG. 2)
AUTOSET CLOCK
The Cube Bluetooth ® Clock Radio is equipped with an autoset clock, meaning the clock
will automatically set itself when first plugged in. Please note: the clock will automatically
default to Eastern Standard Time and will need to be adjusted for other time zones by
manually setting the clock.
MANUALLY SETTING THE CLOCK (FIG. 2)
1. Make sure the Cube is plugged in, but powered off.
2. Press and hold the TIME button to enter Time Setting mode. The hour will begin
flashing. Use the SET TUNE dial to adjust the hour, paying attention to the AM and
PM indicators
3. Once the hour has been set press the TIME button again and the minute will begin
flashing. Use the SET TUNE dial to adjust the minute.
4. Press the TIME button again to set the year, month and day of the week repeating the
steps above.
SETTING AND USING THE ALARMS
SETTING ALARM 1 OR ALARM 2 (FIGS. 1 & 2)
1. Make sure the unit is plugged in, but powered off.
2. Press and hold the desired alarm button (ALARM 1 or ALARM 2) located on the top of
the Cube. The hour will begin flashing.
3. Use the SET/TUNE dial on top of the Cube to adjust the hour, paying attention to the
AM and PM indicators.
4. Press the alarm button again and the minute will begin flashing. Use the SET/TUNE
dial again to adjust the minute.
5. Press alarm button again to adjust the maximum volume of the gradual wake feature
(alarm begins soft and slowly gets louder) by using the SET/TUNE dial to adjust the
sound level up or down.
6. Press the alarm button again to select the source. The Cube’s alarm can be set
to Beep or FM using the SET/TUNE dial. The alarm cannot be set to the
Bluetooth ® source.
7. Press the alarm button again and use the SET/TUNE dial to select EVERYDAY,
WEEKDAYS, WEEKENDS or ONE DAY settings.
8. Press the alarm button again to exit Alarm Setting mode.
TURNING OFF THE ALARM / SNOOZE OPERATION
(FIG. 2)
The Cube Bluetooth ® Clock Radio is equipped with gradual wake, which means that the
alarm begins soft and slowly gets louder. This will ensure a non-jarring wakeup.
• Press the SNOOZE bar located on the top of the Cube and the alarm will sound again
in nine minutes.
Please note: You may only press the Snooze button during the Alarm mode for a half
hour (3 times). After the third time, the alarm will turn off and will not sound again until
the next set time.
• To turn off the alarm, press any button on the top of the unit (except Snooze).
CUBE BLUETOOTH ® CLOCK RADIO
CONTROLS AND CONNECTIONS
(Fig. 1)
(Fig. 2)
1. Set (Time & Alarm)
/ Tune
2. Alarm 1
3. Alarm 2
4. Night Light
5. Source
6. Power
7. Volume +/-
8. Time Set
9. Memory (FM
Preset)
10. Reverse /
Previous Track /
FM Scan Up
11. Snooze/Dimmer/
Sleep
12. Play/Pause
13. Forward/Next
Track/FM Scan
Down
5VDC, 2.5A
FM
Antenna
AUX Line-In
Audio Jack
USB
Charging Port
AC Adapter
Input Jack
5VDC, 2.5A
7 1 5 6 2 3 4
10 11 12 13 9 8