HMDX Sleep Station Plus™ Projection & Weather Alarm Clock EN - Manual (Page 3)

4 5
TURNING OFF THE ALARM / SNOOZE OPERATION
• Press the Snooze bar located on the top of the unit and the alarm will sound
again after several minutes.
NOTE: You may only press the Snooze button during the Alarm mode for one hour
(7 times). After the seventh time, the alarm will turn off and will not sound again until
the next set time.
• To turn off the alarm, press any button (except the SNOOZE/DIM/SLEEP button)
on the top of the unit.
NOTE: To deactivate the ALARM simply press ALARM 1 or ALARM 2.
LISTENING TO THE RADIO
NOTE: For best reception, fully unwind the wire antenna. DO NOT strip, alter or attach to
other antennas.
1. To listen to the radio, press the POWER button located on top of the unit.
2. Press the SOURCE button on the unit until FM icon and station frequency appears on
the display.
3. Use the TUNER selector button on the top of the unit to select desired station. For
auto seek press and hold TUNER selector for 2 seconds and the tuner will find the
next station with the strongest frequency.
4. Press the POWER button to turn radio off.
SLEEP FEATURE
While listening to the radio or AUX source, press the SNOOZE/DIM/SLEEP button to
activate the sleep feature. This allows you to set a sleep timer for 60, 45, 30, and 15
minutes. Once set, the unit will continue playing for the set length of time, then will
automatically turn off.
NOTE: The Sleep Station Plus does not turn off the MP3/AUX device.
PROJECTOR FUNCTION
The Sleep Station Plus is equipped with a cool feature that allows you to project the time
and temperature on any flat surface.
1. To turn projector on, press the PROJECTOR button on top of unit.
2. Carefully move the PROJECTOR device up or down to change where the image
gets projected.
3. To adjust the focus, carefully turn the round end of the projector lens to the
desired focus.
4. Press the PROJECTOR button to turn off.
OUTSIDE TEMPERATURE SET UP
The Sleep Station Plus is equipped with an outside temperature sensor that transmits a
signal and shows the outside temperature on the display.
1. Place 2 AAA batteries (not included) in the Outside Temperature Sensor by removing
the battery cover on the back of the sensor (small Phillips head screw driver required,
not included).
2. Select a secure location anywhere outside but ensure the sensor is within 30 feet of
the Sleep Station Plus.
3. The Sleep Station Plus will automatically receive the signal and display the outside
temperature on the LCD screen.
HMDX SLEEP STATION PLUS ™ ALARM CLOCK RADIO
CONTROLS AND CONNECTIONS:
Power
Alarm 2
Volume
Up/Down
Alarm 1
FM Tuner
Scan Up/Down
Snooze/Dim/Sleep
Projector
Timeset
FM Antenna
C/F
DC5V Input
Projector
ON/OFF
Source
Projector
USB 3.5MM
AUX Cable
Back of Unit