Cambridge SoundWorks NEWTON MC650HD - Manual (Page 8)

8
To place horizontally on a tabletop or shelf:
1. Attach two rubber hook-shaped stick-on feet
symmetrically along the bottom edge of the speaker
approximately 18" apart. If you are mounting the
speaker on an uneven surface you may need to attach
the feet closer to the center. Adapt the actual position
to your needs. You may orient the speaker so that the
terminals are at either end.
2. Slide the rear support into the channel on the rear of
the speaker until it is in the approximate center of the
speaker. Orient it so the foot is along the same side as
the rubber feet you installed in step 1.
3. Tighten the set-screw finger-tight to stabilize the
support.
4. Remove the logo by pulling it straight out. Turn it 90
degrees so that the text reads correctly. Press it back
in place.
HORIZONTAL PLACEMENT
1.
2.
3.
4.