Setting bass contour – Cambridge SoundWorks NEWTON MC650HD User Manual

Page 9

Advertising
background image

9

The switch located near the connection terminals optimizes

the low frequency response of the speaker for wall or stand

mounting.

When the speaker is mounted on a speaker stand,

away from the wall press the end of the switch marked

with “|”.

When the speaker is mounted on the wall or table,

press the end of the switch marked with “O”. The upper

bass range will be slightly attenuated to compensate for

the increase in bass caused by wall reflection.

The above recommendations should yield the most accurate

response in each example, but they are optional. If you pre-

fer the sound with settings opposite the above recommen-

dations, feel free to use your settings instead.

Automatic Tweeter Protection

he MC650HD can be safely used with any receiver rated

above 30 watts per channel. There is little advantage in

using more power than 100 watts per speaker, but receivers

above this power rating can be used so long as the receiver

is not operated at distorted levels.

To protect the tweeter, a self-resetting circuit breaker is

incorporated into the MC650HD crossover network. If the

speaker is overpowered for an extended period, this circuit

breaker will open and the tweeter will be disconnected.

When the volume is reduced or the overload has passed,

the circuit will reset and normal operation will be restored.

SETTING BASS CONTOUR

Advertising
This manual is related to the following products: