Release handle – CHEVROLET 190 User Manual

Page 30

Advertising
background image

DAILY LIVING

D

Do

occ N

No

o:: 21906503 R

Re

ev

v:: 02

Copyright © Hanmar Motor Corporation 2005

B

B--1

16

6

AUXILIARY BATTERY:

The auxiliary battery is located behind the passenger access
door behind the rear wheel, (see Picture B-P46). Under heavy
use it is recommended to check once a month, see
maintenance section.

In order to access the auxiliary battery one must do the
following:

1.

Unscrew wing bolt, (see Picture B-P50).

2.

Pull down on release handle above the exhaust
pipe, (see Picture B-P51).

3.

Lift barrel bolt.

4.

Slide out battery tray.

CAUTION: DO NOT ATTEMPT TO REMOVE BATTERY
COVER WHILE ENGINE IS RUNNING / EXHAUST IS HOT.
HOT EXHAUST CAN BURN.

To reinstall reverse steps above.

CAUTION: BATTERY ACID CAN BURN SKIN AND
CLOTHING. PROTECTIVE EYE WEAR AND GLOVES
SHOULD BE WORN WHEN HANDLING.

Observe all battery warnings and caution labels.

NOTE: Your vehicle is equipped with a group 27 lead acid
auxiliary battery. It is recommended that acid levels be
checked at least once every 3 months. See battery
manufacturers maintenance recommendations.

REPLACING THE AUXILIARY BATTERY:

Ensure that you maintain a minimum of a 3/8 inch clearance
between the battery posts and the top edge of the
compartment. Replacement battery is a group 27 deep cycle
lead acid or equivalent.

Ensure that the battery cable hex nuts are tightened to 10 ft-
lbs, (see Picture B-P52).

Picture B-P51: Location of battery cover release
handle.

Picture B-P52: Auxiliary Battery.

Picture B-P50: Wing bolt.

Wing bolt

Barrel bolt

Release
handle

Advertising
This manual is related to the following products:

170