Casablanca Fan Company Panama 6643Z - Manual (Page 16)

16
® 3
INSTallING The w-85 wall coNTrol
W-85 CoNtroL INStaLLatIoN
1. Use only the Casablanca W-85 wall control.
2. Do not use any additional control with your Inteli-
Touch 3 fan (for example, dimmer, or fan speed
control).
3. Do not use more than one fan per wall control.
4. No other light fixtures or electrical appliances
may be connected on the circuit controlled by the
W-85 wall control.
W-85 is used to describe either white (-11) or almond finish.
If you have multiple Inteli-Touch 3 fans, refer to the section
"Changing Frequency Setting" on page 18.
1. Remove the screws and switch plate from the existing
switch box.
2. Remove the screws holding the switch in the switch
box.
3. Pull the existing switch from the switch box to expose
the wire connections.
4. Remove the two wires from the switch.
5. Connect the BLACK wire from the POWER SOURCE
that you just removed from the switch to the BLACK/
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This
controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this
reason the following precautions must be observed:
caUTIoN!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
Note: The RED wire is not used in this ap-
plication, DO NOT remove the crimped cap
from the wire..
Black aNd whITe
StrIPeD WIre
W-85
Wall Control
2 BLaCk
WIreS
reD WIre
Not uSeD
(fIGure #2)
(fIGure #1)
Note: W-85 Wall Control should only be installed on Casablanca's Inteli-Touch ® 3 fans with DOWNLIGHTS
ONLY.
WHITE STRIP wire on the W-85 wall con-
trol. Secure this connection with a wire nut.
6. Connect the second BLACK wire that you
just removed from the switch to the second
BLACK wire on the located on the back of
the W-85 wall control. Secure this connec-
tion with a wire nut.
7. Connect the green ground wire coming
from the back of the W-85 control to the
ground wire in the switch box. Secure the
splice with a wire nut.
8. Check your work by using the wiring dia-
grams as shown in Figures # 1 and #2.
9. Install the W-85 in the wall box with the
two long screws provided.
10. Install the wall plate with the two color-
matched screws.
SINGLe w-85 INSTaLLaTIoN
W-85