Casio AT-5 - Manual (Page 103)

Using the Pattern Sequencer
E-101
1. While the pattern sequencer screen is
displayed, press the C-6 (RECORD) button.
• The button will start to flash and the Digital Keyboard
will enter record standby.
2.
While holding down the R-13 (FUNCTION)
button, press the C-17 (MENU) button.
• This displays a rec menu screen like the one shown
below.
3.
Use the R-17 (t, y) buttons to select one of
the items described in the table below and then
use the dial or R-14
(–, +) buttons to change the
setting.
• The settings marked with an asterisk ( *) in the “Setting
Range” column are initial defaults.
4.
Press the R-15 (EXIT) button to exit the rec
menu.
• This returns to the pattern sequencer screen.
5.
Press the C-6 (RECORD) button.
• This exits record standby, which will cause the button to
change from lit to unlit.
To configure pattern rec settings (Rec Menu)
Display:
Item name
Description
Setting
Range
Quantize:
Quantize Specify either recording of notes in
the timing they are played on the
keyboard (oFF) or automatic
alignment of notes with a base
note (setting other than oFF).
Selecting a value specifies the
length of each note. “4” specifies
quarter notes, while a “T” setting
specifies triplets. oFF
*
, 4, 8,
8T, 16, 16T
Precount:
Pre-count Specifies whether a precount
should sound before recording
starts after the L-17 (START/
STOP) button is pressed in record
standby. Selecting “1” sounds a
one-measure precount, while “2”
sounds a two-measure precount.
Selecting “oFF” turns off the
precount, so recording starts as
soon as the L-17 (START/STOP)
button or a keyboard key is
pressed. oFF, 1
*
, 2
PlayChord:
Playback
Chords Starting recording of an
accompaniment pattern starts
repeat playback of all the parts of
the pattern, except for the part
being recorded. During such
repeat playback, you can use this
setting to specify the chord type to
be used for playback by bass and
chord parts. Available settings are
“C” (C major), “C7” (C 7th), and
“Cm” (C minor). Selecting “oFF”
turns off bass and chord part
notes. oFF, C
*
,
C7, Cm
Metronome:
Metronome Specifies whether the metronome
should sound (on) or not sound
(oFF) during recording. oFF
*
, on
Display:
Item name
Description
Setting
Range