Axesstel AXW-D1900 - Manual (Page 6)

CDMA 1xEV-DO Wireless Broadband Modem
AXW-D800 / AXW-D1900
- 6 - Connecting the World Now
Safety Precaution
1. Avoid placing the unit in a dusty location, or near a source of gas or fire.
2. Do not shake, hit or drop the unit.
3. To clean the unit, use only a soft, dry cloth. The chemicals in alcohol,
benzine or acetone can damage the surface of the unit.
4. Do not twist or pull the cord out of the unit.
5. Do not disassemble the phone.
6. DO NOT use the power adapter if the power cord is damaged or the
unit has been dropped or damaged in any way.
7. Only use the power adaptor provided by Axesstel. Do not use the
Axesstel adapter for any other purpose.
8. Use only the antenna provided with the unit. Do not use the antenna
for any other purpose.
9. Do not use the unit near water, for example, near a bathtub, sink, wet
basement, or swimming pool.
NOTE: The input voltage and the shape of the plug on this phone may
vary from country to country.
Basic Installation
1. Connect the antennas on the connectors of each side of the unit.
2. Connect the EV-DO modem to computer using RJ-45 Ethernet Cable
(CAT 5) or USB cable.
3. Move the connection selector switch to USB or Ethernet depending on
which cable you are using.
4. Connect the power adaptor to the DC 9V socket of the EV-DO modem.
5. Plug the AC adaptor into an appropriate electrical wall outlet.
Wall mounting…
1. Mark two mounting holes on the wall.
2. Drill two holes at the marked locations.
3. Tighten the screws until the head is about 5mm from the wall.
4. Hang the unit on the screw using the two holes in the back.
5. Push the unit down until the unit is firmly locked into place.