OFNA Racing Ultra MBX R2 - Manual (Page 4)

32237
Rebuild
Kit
2. Pull down piston, attach pressure top
and shock oil overflow with tissue
paper.
SHOCK ASSEMBLY
FILLING THE SHOCKS WITH OIL
ASSEMBLY OF THE SPRING
1. Pull down piston and pour oil into
shock cylinder. Remove air bubbles
by slowly moving piston up and down. 3. Tighten up shock cap.
*Move Slowly.
*Leave 3mm.
*Push onto shock
cylinder.
Shock Shaft
Piston
Silicone
Oil
Dust Pusher, Short
(Yellow Rubber)
Option:
32205
Dust & Shaft
Protector, long
Oil Seal
* Fit into groove.
2mm
Washer
1mm
Washer
7mm
E-Ring
* Note the E-Ring must
fit into groove as shown.
32051
6mm Ball End
32051
6mm Ball End
* Long shaft
for rear.
2.6mm Nut
* Push 6mm ball joint
into ball end.
2.6 x 5mm
Washer
Spring Collar
Spring Holder
*Slide spring collar into Shock.
5mm
3mm
1mm
*Spring Tension adjust . er
(Standard)
30403
6mm
Ball Joint
Optional...
32330
Set, Red Springs, Front & Rear
32340
Set, Yellow Springs, Front & Rear
* Screw down cap.
32033
Pressure Top
32043
Cap, blue
* Fit into groove.
* Assembly 4 pieces of the
shock shaft .
32292
Front, 3.5mm
Short Shaft
30671
Front Shaft, 3.5mm
with Piston
30672
Rear Shaft, 3.5mm
with Piston
32236
Rear, 3.5mm
Long Shaft
32203
E-Ring
* Be careful not to damage shock shaft.
Sc
re
w
Ce
m
en
t
* Short shaft
for front.
down.
UP
( Make 2 for front.)
( Make 2 for rear. )
32051
Misc. Plastic Shock Parts
32051
Misc. Plastic Shock Parts