OFNA Racing X3 Sabre - Manual (Page 36)

66
NO.11
BAG
ASSEMBLY OF THE BATTERY BOX AND RADIO TRAY
ADJUSTING THE ENGINE CONTROL LINKAGES 67
•Turn on the Transmitter then Receiver and set the
Engine Control Servo Trim at the neutral position.
•Adjust the idling adjusting screw on the Carburetor
to be open approx. 1mm gap.
•Adjust both of the 41513 Engine Control and Brake linkage
accordingly.
•Adjust the Engine while it is not running.
•Adjust the Servo-Horn mounting position for the
Carburetor to be full open.
•Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
if it is opening excessively. Or if available on the
Transmitter, adjust the Throttle high end point.
•Adjust 41513 so the brakes work smoothly.
•If the brakes apply too much or not enough,
adjust 41514 accordingly. Or if available on the
Transmitter, adjust the High-End Brake
adjustment.
•Adjust 41514 and 41513 to Change the front or
rear brake.
.
Approx. 1mm gap
(Neutral) (Throttle High) (Brake)
Idling adjusting
Screw
Approx. 0.5mm
Carburetor is Opening fully
41513
Step 1
Step 2
Step 3
94033
3x3mm
Set Screw
.....x2
Step detail
41514
41359 41328
94033
94033
41513
41359
41336
41328
41514
41513
41514