OFNA Racing GTP Rear Pivotball & Anti-roll Kit -- 31296 - Manual

* Insert drive shaft
before assembly.
Assembly of the right and left hand side
are the same.
* A 4 x 10mm set screw is used
to adjust the ride height.
* Insert into cap.
ASSEMBLY OF THE ANTI-ROLL BAR
31302
Anti-Roll Bar
Mount
(Left)
31302
Anti-Roll Bar
Mount
(Right)
31308
Anti-Roll Bar
31308
Anti-Roll Bar
3x3mm
Set Screw
3x3mm
Set Screw
Rear Pivot Ball & Anti-Roll Bar Suspension Kit For "ULTRA GTP" #31295
36870
4x10mm
Set Screw
31301
4x80mm
Lower Arm
Shaft
ASSEMBLY OF THE NEW FRONT LOWER ARM
1 2 REMOVE THE FRONT STABILIZER
AND PARTS BAR FROM YOUR CAR.
R
0
1
R
REPLACE THE OLD FRONT LOWER ARMS WITH
THE NEW ARMS.
This rear pivot ball kit is suitable for those who already have "ULTRA GTP" car kit.
* Follow these instructions to assemble this kit.
* Approx 3mm. 3
4
30152
Upper arm Shaft
90021
3mm
E-Ring
90021
3mm
E-Ring
0
1
R R
INSERT THE NEW FRONT
LOWER ARM SHAFT.
36670
Caster Angle
Adjuster
ASSEMBLY OF THE UPPER ARM SHAFT
AND THE CASTER ADJUSTER
* Builds two sets of anti-roll bars for the front and rear.
36890
Front Lower
Arm
90021
3mm
E-Ring