Pigtronix Echolution Chrome - Manual (Page 11)

LOOP – Come Again
29. Set the Modulation Delay Range switch to the long (L) setting. Put the
Echolution in Modulation Delay mode by clicking the Modulation Delay
footswitch. Bring the BLEND control back to 12:00 and turn off the reverse
switch.
30. With the 3/4 tap turned on, play something and then flip the LOOP switch.
Whatever was going through the delay line is now captured as a sample.
31. Turn on the other multi tap switches to change the rhythmic content of
the loop.
32. Modulate the loop by turning up the Chorus and Tremolo knobs.
33. Change the position of the delay time range switch to medium (M).
34. Change the setting of the delay time control. As you turn it clockwise,
the pitch of the loop will get lower. As you turn it counter-clockwise,
the pitch of the loop will get higher.
35. Change the position of the delay time range switch to medium (S). Now the
loop will become a droning tone.
36. Crank up the LFO speed and TREMOLO controls all the way and then
change the position of the delay time control.
37. Switch different combinations of the multi-tap switches on and off to get
different timbres.
38. Put the Modulation Delay range switch back to long (L) setting and turn the
Chorus and Tremolo controls full counterclockwise.
39. Turn off the LOOP function and keep playing!
Remote Switch – Loop and Reverse on the Fly
Both the REVERSE and LOOP functions can be turned on and off remotely with
an optional two button TRS latching footswitch.
A single button latching footswitch can be used with a mono cable to operate
the LOOP function only.