Vernier Data Pro - Manual (Page 45)

Data Pro 43
Appendix E: Data Pro Sensor Setup Default Settings
The table that follows shows the default settings used by the Data Pro program as well as the
Quick Setup feature of LabPro. This sensor and calibration information applies only to
Vernier and TI sensors. The use of other manufacturers’ sensors may require calibration or
the input of that sensor’s calibration information into Data Pro.
Note: Default settings apply only when using a single sensor that is connected to Channel 1.
Sensor Name Short Name Y-Min Y-Max
Sample
Interval
(in
seconds)
No. Of
Samples
Dir connect Temp (
°
C) TEMP(C) -15 110 1 180
Dir connect Temp (
°
F) TEMP(F) 0 250 1 180
Extra Long Temp (
°
C) TEMP(C) -50 150 1 180
Stainless Temp (
°
C) TEMP(C) -20 125 1 180
Stainless Temp (
°
F) TEMP(F) -5 260 1 180
Thermocouple (
°
C) TEMP(C) -200 1400 1 180
Surface Temp (
°
C) TEMP(C) 0 50 1 180
pH PH 0 14 2 60
Conduct 200 (
µ
S) CONDUCT
(MICS)
0 200 1 180
Conduct 100(mg/l) TDS(MG/L) 0 100 1 180
Conduct 2000(
µ
S) CONDUCT
(MICS)
0 2000 1 180
Conduct 1000(mg/l) TDS(MG/L) 0 1000 1 180
Conduct 20000(
µ
S) CONDUCT
(MICS)
0 20000 1 180
Conduct 10000(mg/l) TDS(MG/L) 0 10000 1 180
Gas Pressure (kPa) PRESS
(KPA) 50 150 10 90
Gas Pressure (mm Hg) PRESS
(MMHG) 400 1200 10 90
Gas Pressure (atm) PRESS
(ATM) 0.5 1.6 10 90
Gas Pressure (in Hg) PRESS
(INHG) 0 65 10 90
Pressure (kPa) PRESS
(KPA) 0 700 1 180