Sangean U4 DBT (V1) - Manual (Page 45)

44
GB
System reset
If your radio fails to operate correctly, or some digits on the display
are missing or incomplete carry out the following procedure.
. Press the Power button to switch on your radio.
. Press the Menu button until the Advanced menu of current mode
shows on the display.
3. Rotate the Tuning control until 'System ' appears on the display.
Press and release the Tuning control.
4. Rotate the Tuning control until 'Factory Reset' appears on the
display. Press and release the Tuning control.
5. Rotate the Tuning control until 'Yes' is highlighted on the display
and press and release the Tuning control. A full reset will be performed.
The station list and presets will be erased. Alarms will be cancelled
and sleep timer settings will be set to their default values. The
display will show 'Welcome to Digital Radio' and the unit will behave
as when first switched on.
If you do not wish to carry out a system reset, highlight 'No' and
then press the Tuning control. The display will revert back to the
previous display.
In case of malfunction due to electrostatic discharge, reset the
product using the above procedure. In some circumstances it may
be necessary to disconnect and then reconnect the mains power in
order to resume normal operation.