Sangean DAR-101 (R1) - Manual (Page 12)


Setting the Clock and Date
Setting the clock time
Note:
It is important to set the clock time/ date before recording, as all the name of recorded files are
created based on the recording time and date.
The clock display of DAR-0 can be set to  or 4 hour format.
. Press the Menu button while the recorder is switched on.
. Rotate the Tuning control until SYSTEM SETUP is highlighted, and press the Enter button to
enter the setting.
3. Rotate the Tuning control until TIME & DATE is highlighted, and press the Enter button to enter
the setting. Rotate the Tuning control until TIME is highlighted, and press the Enter button to
enter the setting.
4. Rotate the Tuning control until TIME FORMAT is highlighted, and press the Enter button to enter
the setting. Rotate the Tuning control to select either  or 4 hour format as desired. Press
the Enter button to confirm the setting, and the display will revert to the previous setting.
5. Rotate the Tuning control until TIME SET is highlighted, then press the Enter button to enter
the setting. While the hour digit is flashing, rotate the Tuning control to select the appropriate
hour as shown on the display. Press the Enter button when you finish the setting.
6. Rotate the Tuning control to select the appropriate minute as shown on the display while the
minute digit is flashing. Press the Enter button to confirm the setting.