Talkaphone ETP-CDMA-V CDMA Cellular Interface - Manual (Page 6)

ETP-CDMA-V
– Cellular Interface
Installation Instructions
Page 6 of 6 Rev. 12/12/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement, sponsorship, or affiliation
with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
The Verizon Wireless representative will instruct you to complete the provisioning process by temporarily
connecting a telephone test set or standard analog touch-tone telephone to the ETP-CDMA-V Cellular
Interface.
Using the telephone test set or standard analog touch-tone telephone, bring the telephone off-hook and dial
*228 . Listen for the Verizon Wireless voice prompt indicating a successful or failed provisioning process. If the
voice prompt indicates failure, try the *228 provisioning process again or request assistance from the Verizon
Wireless representative. If successful, bring the telephone on-hook, and then bring the telephone off-hook to
verify that a dial tone is present.
Once dial tone is present, field installation of the ETP-CDMA-V Cellular Interface can begin and the ETP-400
Series Phone can be connected.
VII. Programming the ETP-400 Series Phone
The ETP-400 Series Phone requires specific programming for operation with the ETP-CDMA-V Cellular
Interface. At minimum, the ETP-400 Series Phone should be programmed with the following codes:
* 4 **
* 13 * <Phone_Number> # *
* 14 * 3 *
* 18 * 5 *
* 24 * 0 *
* 27 * 0 *
* 55 *
* 56 *
* 58 * <Speak_to_Record_Voice_Message> (Optional)
* 72 *
* 103 *
For a full comprehensive list of programming codes, reference the Installation & Operation Manual for
Emergency/Information Phones.
NOTE: The hash or # appended after the <Phone_Number> (i.e. for the * 13 * <Phone_Number> # * code) is
only required if the Intelli-Voice option (V-Chip) is used on the ETP-400 Series Phone.