Talkaphone ETP-PMD-SS Dual Faceplate Stainless Pedestal Mount - Manual

Pedestal Mount Installation Instructions
Copyright 2014 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 4/7/2014
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
I.
Introduction
NOTE: This manual is for anchor bolts installation into the foundation and the pedestal installation for models
ETP-PM, ETP-PM-SS, ETP-PMD, and ETP-PMD-SS.
II.
Contents
Before beginning installation, make sure you have all the included components. Each Pedestal consists of two
packages. Package #1 contains the pedestal itself. Package #2, labeled PARTS contains the following:
Anchor Bolt Install Kit
QTY
Part Number Description
4 42838 J-Bolts
1 24717 Aluminum Template
Pedestal Install Kit (keep for use when installing the pedestal)
QTY
Part Number Description
6 42867 10-24 x3/4" oval head tamperproof screw
8 42839 3/4"-10 Hex Nut
8 42840 3/4" Washer
2 42843 6-32 hex nut
1 67478 Polycarbonate light cover
1 68590 LED light board (12-24V AC/DC - 120VAC)
III.
Foundation Preparation
1. Electrical and telephone line conduits should be run through the foundation and into the center 4"
diameter hole of the pedestal.
NOTE: To insure proper grounding of all electrical components, the pedestal mount should be
effectively earth grounded from the grounding stud (located across from the lower access panel) with
6 AWG or better insulated, stranded copper wire to the metallic power service raceway (conduit) or an
8 foot or longer corrosion-resistant ground spike. It is the installer's obligation to ensure compliance
with all national, regional, and local regulations.
2. Pour the foundation at least 2 feet in diameter and 3 feet deep according to your local code and frost
line (see foundation drawing on following page).
3. Install the four (4) 3/4” - 10 x 24 long anchor bolts below grade with five inches (5”) projecting
above grade (see foundation drawing on following page). Use the template provided to properly
position the bolts within the concrete foundation.
NOTE: Make sure all connections meet National, Regional, and Local Electric Codes.