Talkaphone ETP-UPS Back-up Power Supply - Manual (Page 7)

Customer support and warranty information is available at the APC Web site, www.apc.com.
© 2009 American Power Conversion. All rights reserved. All APC trademarks are property of American Power
Conversion. Other trademarks are property of their respective owners.
990-3583
06/2009
Specifications
APC Worldwide Customer Support
General
Topology
Line-Interactive
Input
Rated input voltage
120 Vac
Phase Single phase 2+ ground
Frequency 50/60 Hz (autosensing)
Input voltage range
(on AVR operation)
Default setting: 88 V-141 V
Lower Limit Voltage Range: 78 V- 144 V
Upper Limit Voltage Range: 88 V- 137 V
Power cable length 6 ft
Input plug type NEMA5-15
Output
Output plug type
NEMA5-15R
Output outlet Back-up outlets (3)
Surge outlets (3)
Maximum load 700 VA/420 W
Output voltage 115 Vac + 8%
Frequency 50/60 Hz +1
On-battery waveform Stepped sine wave
Transfer time Maximum 8 ms
Surge Protection/Noise
Surge protection
Yes
Noise filter Yes
Data line protection ADSL, ISDN, 10/100Base-T
Interface
Interface
USB v1.1
Technical Support http://www.apc.com/support
Internet http://www.apc.com
Worldwide +1.401.789.5735
Service
If the Back-UPS arrived damaged, notify the carrier.
If the Back-UPS requires service, do not return it to the dealer.
1.Consult the Troubleshooting section to eliminate common
problems.
2.If the problem persists, go to http://www.apc.com/support/.
3.If the problem still persists, contact APC Technical Support.
Have the Back-UPS model number, serial number and date of
purchase available. Be prepared to troubleshoot the problem
with an APC Technical Support representative. If this is not
successful, APC will issue a Return Merchandise Authoriza-
tion (RMA) number and a shipping address.
Warranty
The standard warranty is three (3) years from the date of pur-
chase. APC’s standard procedure is to replace the original unit
with a factory reconditioned unit. Customers who must have the
original unit back due to the assignment of asset tags and set de-
preciation schedules must declare such a need at first contact
with an APC Technical Support representative. APC will ship
the replacement unit once the defective unit has been received
by the repair department, or cross-ship upon the receipt of a val-
id credit card number. The customer pays for shipping the unit
to APC. APC pays ground freight transportation costs to ship
the replacement unit to the customer.