Talkaphone HS-RF-1 Wireless Headset User Manual
Page 2
HS-RF-1 Wireless Headset System Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 2 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Plug the Base power Adapter into the wall outlet, then plug the power cord into the YELLOW labeled
connector on the bottom of the headset Base. The RED Power light on the left front of the Head set Base will
turn on.
IV. Charge the Headset for at least 20 minutes before using
Gently push the headset into the charging cradle as shown. The AMBER charge status light on the base will
flash to indicate the headset battery is charging. A solid light indicates full charge. A full charge will take
approximately 3 hours.
Connect RJ-11 to Headset port
of IW-HFM-4