Talkaphone VOIP-201C Surface Mount Single Button Compact IP Call Station - Manual (Page 4)

VOIP-200 Series IP Call Station
Configuration and Operation Manual
Page 4 of 8
Copyright 2014 Talkaphone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone Co. All rights reserved.
2. Getting Started
2.1. Pre-requisites
Prior to configuring a VOIP-200, ensure the unit is powered on and connected to the network.
The VOIP-200 can be configured from a computer with a TCP/IP network connection and it also supports
straight-through serial connections for basic programming. For access to the full configurable feature set, a
modern web browser will be required.
2.2. Configuration Using the Web GUI
Ensure both the VOIP-200 and your PC are connected to the Local Area Network. A direct connection to 1.
the VOIP-200 will require the use of a crossover network cable.
VOIP-200 are pre-configured with the following default settings:
IP Address: 169.254.1.100
Username: admin
Password: alphaadmin
Configure the IP address of your PC to be on the same subnet as the VOIP-200. For example, 2.
169.254.1.101
Open a supported web browser and direct it to the IP address of the VOIP-200. For example, enter the 3.
following URL: http://169.254.1.100
The browser should prompt for authentication. 4.
Enter the default Username and Password. After authentication is successful, you are redirected to the 5.
Home page.
Further configuration of VOIP-200 settings are examined in Section 4: Using the Web GUI. 6.