Talkaphone VOIP-201C Surface Mount Single Button Compact IP Call Station - Manual (Page 8)

VOIP-200 Series IP Call Station
Configuration and Operation Manual
Page 8 of 8
Copyright 2014 Talkaphone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone Co. All rights reserved.
3.5. Set Date& Time
3.5.1. Time Settings:
Select Enable NTP to set the VOIP-200 to use Network Time Protocol. 1.
If using NTP, enter the Hostname/IP Address of the NTP Server. 2.
If using NTP, select the Time Zone from the drop-down menu. 3.
If manually entering the date and time, enter the Date in yyyy-MM-dd-hh-mm format. 4.
Click Save to save settings. NTP settings will automatically update the date / time. 5.
3.6. Relay
3.6.1. Relay Settings:
Remote Digit For Relay ON: Specify the digit entered during a conversation to activate the relay until a 1.
de-activation event occurs.
Remote Digit For Relay OFF: Specify the digit entered during a conversation to de-activate the relay. 2.
Remote Digit For Timed Relay On: Specify the digit to turn ON the relay for a specific duration of time. 3.
When this digit will is pressed during a conversation, the replay will remain on for the duration of the
time specified under the ‘Timed Relay Duration’ field.
Outgoing Call: Specify the relay state when the button is pressed. To activate the Talkaphone strobe 4.
light connected to the Auxiliary Output, set this value to ‘ON’.
Idle: Specify the relay state when the VOIP-200 returns to an Idle state after the call terminates. To de- 5.
activate the Talkaphone strobe light after the call is complete, set this value to ‘OFF’.