Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers - Manual (Page 3)

WEBS-RETRO-MT Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 3 of 4
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
4) Place a washer along with the amplifier mounting bracket on the desired anchor bolt. After adjusting
the mounting plate with the help of the obround slotted hole, fasten the plate to the anchor bolt with
another washer and hex nut (see Figure 2).
Figure 2. Installing the Paging Amplifier: (5) Paging Amplifier, (6) Amplifier Mounting Bracket, (7) 3/4"-10 hex nut, (8) 3/4"
washer, (9) Anchor bolts, (10) 3/4"-10 hex nut for tightening anchor bolts (11) Base plate of tower, (12) 3/4"-10 hex nut for
leveling anchor bolts
NOTE: Depending on the length of threading available on the anchor bolt, you may need to use the additional
washers provided to elevate the amplifier mounting bracket so that the anchor bolt does not interfere with the
amplifier. If there is not enough threading available to install as shown above, either do not use the additional
washers, or remove the existing nut and washer and mount directly above the tower base plate.
Because this kit is being added to existing towers, installers may find conduit, electrical boxes and other objects
obstructing the area above the anchor bolts where the amplifier brackets mount. These brackets can be installed
on any 2 of the 4 anchor bolts—if you find that it is not possible to fit the brackets in the towers due to specifics of
your existing installation, please call Talk-A-Phone technical support for help.