Talkaphone WEBS-ZPS Zone Paging System for Analog WEBS - Manual (Page 3)

WEBS-ZPS Zone Paging System Instructions
Copyright © 2011 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 3 of 7
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Option B:
If the first module of the WEBS-ZPS unit does not have a 7-pin DIP switch (TEL INT SEL) as shown in
Figure 3, please refer to the following set of instructions:
Figure 3. WEBS-ZPS without 7-pin DIP switch (TEL INT SEL).
Use a modular RJ11 telephone cord (minimum 2-conductor) to connect the module to the phone interface
system.
For PBX Station Access/CO Line Configuration, move the TELEPHONE INTERFACE SLIDE switch on
the module to the position shown in Figure 4 (i.e. STATION). The two center conductors of the RJ11 cord
are TIP and RING and are not polarity sensitive. Plug one end of the RJ11 telephone cord to the PBX or
CO modular jack and the other end in to the STATION jack on the module.
Figure 4. WEBS-ZPS (without 7-pin DIP switch) for a PBX Station Access/CO Line configuration.