Storix Software SBAdmin Linux System Recovery Guide - Manual (Page 74)

Configure Remote Install Manager
If you configured RIM at the time you created the boot media, it will be automatically enabled and it will not be
necessary to configure in this option. If, however you did not pre-configure RIM, or if you need to change the
RIM configuration, you make changes from within the system Installation menus after booting from the SBAdmin
boot media. To do so, select the
System Recovery Utilities option from the main menu to display the following:
Select Configure Remote Install Manager . The following screen will display:
1. The Remote Install Username is set to “sbadmin” and may not be changed. Enter a password in the Remote
Install Password field. The password will be necessary to login to the remote install client.
2. Select the Network Device (adapter) that should be configured to connect to the remote install client.
3. Enter the IP Address used to configure the network adapter. Note that, if the selected adapter is already
configured (as a boot or install device) and you enter a different IP address than the adapter is currently
using, you will be provided a warning and allowed to continue. If you do so, however, the previous settings
will no longer apply, and the adapter will be reconfigured under the new IP address.
4. Enter the Subnet Mask (if necessary) used when configuring the network adapter. As with the IP Address, if
the adapter is currently configured under a different subnet mask, you will be warned and allowed to
reconfigure the adapter under the new subnet mask.
Storix System Backup Administrator 74 Version 8.2 Linux System Recovery Guide