BendixKing KMD 150 - Pilots Guide - Manual (Page 114)

100
Rev 3 Aug/2004 KMD 150 Pilot's Guide
If you press Key 3, labeled "CLEAR WPTS", a similar procedure will be
followed, and pressing, "YES" will this time clear all User waypoints from
memory including those being used in Flight Plans.
Use of Key 4, labeled "CLEAR SETUP", will reset all the User-Defined
Options within the unit to their original default values. This also clears
the Note Pad memory.
Key 5, labeled "CLEAR LOG", resets the Total Time Run counters that
appear on Screens 30 and 31. This also clears the last flight time log
and the 2000 in flight logged points from memory.
Key 1, labeled "PREV PAGE", returns you to Screen 28 without altering
or erasing anything in the unit's memory.
DATA IN/OUT
On entry to this Screen,
details of the current set-
tings for data output are
displayed in the top box
and a cursor is posi-
tioned over the words
DATA OUTPUT.
Settings for data output
can be adjusted using
the joystick and the
options available are as
follows. (The default set-
tings are listed first.)
External GPS Source selected: DATA OUTPUT: OFF /
ECHO INPUT.
Internal GPS Source selected: DATA OUTPUT: OFF /
RS232 (AR NAV) / NMEA
0183
Data output when using an external GPS receiver is limited to echoing
the data input. This provides a useful RS232 buffer for connecting other
listening devices to the host GPS data output.
KMD 150 with GPS can output standard aviation RS232 data or NMEA
0183 format RMC and GGA sentences at 9600 baud.
Below the DATA OUTPUT setting is the STORMSCOPE setting. If the
KMD 150 is interfaced to a L-3 Communications WX-500 Stormscope
®
sensor, this option should be selected to ON. If selected ON, Key 2 will
be labeled STORMSCOPE and will give access to screen 64, the
Stormscope
® diagnostics cover page. These are not screens, which you
as a user of the KMD 150 should need to access, however if further
Setup Screens
Screen 35: Data Input/Output Setup and
Test Screen