BendixKing KSN 770 - Pilots Guide - Manual (Page 428)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 15-155
Flight Management System (FMS)
Honeywell International Inc. Do not copy without express permission of Honeywell.
When the mode is FLT PLAN , the Flight Plan touchscreen softkey
is displayed in 1L which permits the pilot to choose from stored flight
plans to use for origin and destination calculations. In addition,
Flight Leg is displayed in the center of the page and to the right of the
Flight Plan touchscreen softkey, as shown in Figure 15--145. The
flight leg function permits the pilot view trip planner on a leg--by--leg
basis. The flight legs are changed by using the interactive touchscreen
to push the PREV or NEXT touchscreen softkey or by rotating the
joystick knob as indicated by FLT LEG displayed in the lower--right
corner.
Present position is selectable when the current GPS position is valid.
When the mode is PPOS , the present position latitude and longitude
are displayed in cyan in 1L, which uses the present aircraft position as
the origin waypoint. When the current GPS position is not valid, last
know GPS position is selectable. When the mode is LAST POS , the
last valid GPS position is displayed in 1L and used for calculations.
Sunrise/Sunset -- The sunrise and sunset times at the destination are
displayed in this field.
DTK -- The desired track from the origin waypoint to the destination is
displayed in this field when the mode key in 2L is WPT . The desired
track from the present position (or last GPS position) to the destination
is displayed in this field when the mode key in 2L is PPOS (or
LAST POS ). The desired track from the selected flight plan leg is
displayed in this field when the mode key in 2L is FLT PLAN and a
valid flight plan exists.
ETE -- The estimated time en route to the destination in HH:MM:SS
(hours:minutes:seconds) format is displayed in this field.
ETA -- The estimated time of arrival at the destination is displayed in
Zulu in this field.
Date -- The date is entered by selecting the Date touchscreen softkey.
Ground Speed -- The planned groundspeed is entered in knots by
selecting the Ground Speed touchscreen softkey.
Destination -- The Destination touchscreen softkey is displayed
when the mode in 4L is either WPT or PPOS. The pilot can manually
define the destination waypoint in this mode. The STORED/ACTIVE
touchscreen softkey is displayed when the mode in 2L is FLT PLAN.
The pushing the STORED/ACTIVE touchscreen softkey toggles the
destination from the stored flight plan or the active flight plan
destination.