BendixKing SILVER CROWN PLUS System SILVER CROWN PLUS - Manual (Page 28)

Silver Crown Plus Pilot’s Guide
24
extend the operating life of your
equipment.
Transmitting
During COMM transmissions, a
“T” will appear between the “USE”
and “STBY” windows to indicate the
keying of the microphone.
KY 196A/197A Frequency
Mode
(Normal Operation)
1. Select a new frequency in the
“STBY” window, using the frequency
selection knobs. The larger knob
controls changes in increments of
1MHz. The smaller knob controls
changes in increments of 50kHz when
pushed in, and 25kHz when pulled
out.
At the outside limits of the band, the
display will “wrap around” to the other
end of the band, going from 136MHz
to
118MHz.
2. Press the transfer button to activate
the new frequency. The newly entered
frequency in the “STBY” window flip-
flops with the frequency in the “USE”
window. This new frequency is now
available for use. An optional remote-
mounted frequency transfer button
may also be used to perform this “flip-
flop” function.
KY 196B Frequency Mode
(Normal Operation)
1. Select a new frequency in the
“STBY” window, using the frequency
selection knobs. The larger knob
controls changes in increments of
1MHz. The smaller knob allows
selection of 25kHz frequencies only
when pushed in, and both 8.33kHz
and 25kHz frequencies when pulled
out.
At the outside limits of the band, the
display will “wrap around” to the other
end of the band, going from 136MHz
to 118MHz.
2. Press the transfer button to activate
the new frequency. The newly entered
frequency in the “STBY” window flip-
flops with the frequency in the “USE”
window. This new frequency is now
available for use. An optional remote-
mounted frequency transfer button
may also be used to perform this “flip-
flop” function.
Program Mode
The Program Mode is used to
program frequencies for use in the
Channel Mode.
1. Depress the channel (CHAN)
button for more than two seconds,
until the channel number (to the right