BendixKing SILVER CROWN PLUS System SILVER CROWN PLUS - Manual (Page 29)

KY 196A, KY 197A and KY 196B
25
of the standby frequency) begins
flashing. The most recently used
active frequency will remain displayed
in the “USE” window.
2. Turning either frequency selection
knob will change the channel.
3. Once you’ve selected the desired
channel number, you may program a
new frequency by pressing the
transfer button. This will cause the
frequency in the “STBY” window to
flash. The tuning knobs are now used
to enter desired frequency.
4. To program additional channels,
push the transfer button again to
make the channel number flash, and
repeat step three above.
5. If you with to program fewer than
nine channels while skipping certain
channel numbers, rotate the MHZ
frequency knob left or right beyond
136MHz or 118MHz. Dashes (---) will
appear in the “STBY” window,
indicating that the channel will be
skipped when the system is operating
in the Channel Mode.
6. To exit the Program Mode,
momentarily press the channel button.
The unit will also automatically exit
the Program Mode if no programming
occurs within approximately 20
seconds.
The Program-Secure Mode
The Program Secure Mode may
be used to lock a desired frequency to
a specific channel number, prohibiting
program changes from the front of the
unit. Your KY 196A, KY 197A or KY
196B should be taken to your
Bendix/King dealer for programming
in the Program Secure Mode.
Channel Mode
The Channel Mode is used to
recall preset frequencies stored in
memory.
1. To enter the Channel Mode
momentarily, push the channel button
while in the Frequency Mode. The
active frequency remains displayed in
the “USE” window, and the last used
channel number and its associated
frequency are displayed in the
“CHAN” and “STBY” windows.
If no channels have been
programmed, channel 1 automatically
disappears and dashes are displayed
in the “STBY” window.
2. Turn either frequency selection
knob to change the channel number