CANOGA PERKINS 2262 T1/E1 Fiber Optic Modem - Manual (Page 18)

18
Canoga Perkins 2262 T1/E1 Fiber Optic Modem
4.2.2 Link Diagnostic Procedure
Symptom Step Possible Cause Remedy
Tx LED is off 1 Reversed data input and Swap T1/E1 data input
output connection. and output cable
connection.
2 No data input at See Section 4.2.3,
metallic interface. Loopback Diagnostic
Procedure, step 1.
Tx LED is off 3 Unit failed. Return to factory for
repair.
Rx LED is off 1 Reversed optic transmit Swap the optic transmit
and receive connection. and receive cable
connection.
2 Local or remote side See Section 4.2.3,
system or fiber optic Loopback Diagnostic
link failure. Procedure, steps 2 to 4.
High error rate 1 Bad optical connection. Clean the optic connec-
tor end surface.
2 Local or remote side See Section 4.2.3,
system or fiber optic Loopback Diagnostic
link failure. Procedure, steps 1 to 4.