CANOGA PERKINS 2345 T3 Fiber Optic Modem - Manual (Page 25)

EdgeAccess Universal Chassis System
Model 2345 User Manual 3-9
If you do not have a script file, you dial in through a modem, and the networking option is set to
VT100 operation, you will not see the screens, but the 2345 responds to the commands normally.
Follow these steps:
1. Dial in through a modem, then type your user name and password and press <Enter>.
2. Type 1 and press <Enter>.
3. Type 5 and press <Enter>.
4. Type 6 and press <Enter>.
5. Press <Space> once for SLIP mode or twice for PPP mode, then press <Enter> to confirm the
port choice.
The 2345 is ready to run TCP/IP applications.
Set the VT100 Rate
Although the default rate the VT100 meet requirements for most systems, you made need to change it
for your particular situation. To reset the baud rate, follow these steps:
1. At the Main menu, type 6 , "Utilities," and press <Enter>.
2. At the Utilities menu, type 3 , "VT100 Baud Rate," and press <Enter>, then press <Space> to
cycle between 9600 and 19200 bps.
3. To return to the Main Menu, press <Esc>.
Update Software
Each module in the Universal Chassis System has two flash memory banks that store software:
• The Active Flash Memory holds the software currently in use
• The Inactive Flash Memory holds the new software from a download or the older version of
software
Software is downloaded to the inactive region to avoid disrupting service. Resetting the module and
swapping banks does not affect module operation and is transparent to user traffic.
Use the Software Upgrade report and menu screen to check the current version of the 2345 firmware
and to upgrade software for any module in the domain or a managed module partner, if necessary.
To access the Software Upgrade screen, follow these steps:
1. At the Domain Management Module menu, type 4, Software Upgrade, and press <Enter>. The
Software Upgrade screen appears.
2. Record the numbers for the Active and Inactive Firmware.