CANOGA PERKINS 2461 E1 Modem User Manual
Page 65
EdgeAccess Universal Chassis System
A modem can be manually switched from inactive to active for the following reasons:
1) To bring the modem into standard use.
2) To test with a full data payload for quality verification purposes.
3) To track down an unknown, intermittent error, and determine if this modem is the source of
it.
Note: Switching from redundant mode to a non-redundant modem mode does not
require that you replace the redundant ELIMs. You can use redundant ELIMs for
normal modem operation (As long as the Auto-Switching redundancy mode is off).
Figure 45. Link Self Test running continuously on an auxiliary channel at 64 kbps
Fiber Logic LIU
LIU Logic Fiber
Central Office
DTE
BER
BER
DET.
GEN.
BER
BER
GEN.
DET.
2461 Modem User Manual
7-7