Line data input, Backing line 2), Attention – Daiwa TANACOM 1000 User Manual
Page 17
Advertising
15
7
Should “
Err
” appear on the display, then use the
MODE SET
BUTTON
to re-enter the data.
6.
Pull an additional 50m of line from the spool.
7.
Press the
RESET BUTTON
for 2 seconds to show
100.0
on
the upper counter.
8.
Wind up the 100m of line you pulled from the reel. This
completes the procedure.
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF, and wind manually when nearing the end of
the line.
2.There are cases in which the length of the line will not be displayed if it exceeds 100m
when entered with this method.
Line data input
(Backing line 2)
Advertising